Lyata Screed

A factory prepared blend of carefully selected raw materials, cement and graded fillers, it is designed for use with water and aggregate to produce high strength, water retaining and self-curing screed for interior and exterior floor applications.it meets and exceeds the requirements of national and international standards.

Fassade

Fassade is a blended powder polymer modified cement based tile adhesive specially designed for heavy duty tile  application like ceramic tiles, vitrified tiles, stones, quarry tiles, pavers and bricks.It contains  highest grade of graded sand cement, selected filler, polymers and chemical additives to give it unique binder properly.

Area of application:. Excellent for facades and underwater applications. Both interior and exterior areas. This highly flexible adhesive has excellent waterproofing ability making it ideas for fixing ceramics,glazed surface, natural stone etc. On new surface.

Certification:
(1) ANSI:A118ET/11, (2) EN12004 FOR C2TES1, (3) VOC:NIL

Coverage: Coverage: Approx. 50-55sq.ft./20kgs bag at 3mm thickness.

Performance Data: Exceeds ANSIA 118.4ET/11(EGP) EN 12004 FOR C2TES1.

Shelf Life: 24 Months in unopened condition store in cool and dry place.

Advantages:
1.Ready to use .only water has to be added.
2.Better bond than conventional cement based mortar
3.Waterproof as it provides partial impermeability of water into concrete
4.Excellent adhesion and low shrinkage.
5. Sufficiently flexible to accommodate thermal and physical movements.
6.Needs no curing and soaking of substrate.
7.Needs no hacking or mechanical key on the surface
8.C an be used on new at wall as old wall & floor.
9.Cost effective.

Direction for use:
* Surface preparation.
*The surface to be tiled must be free from loose particles dirt grease and traces of foreign material by using wired brush/stand paper or by chipping if necessary
*For loose plaster areas ,remove defective materials and re-plaster the area.
*New construction must be 6 weeks old.
*Old construction must be clean and made good with sand cement slurry bonding cost prior to applying this adhesive.

Mixing
*Mix three part of Fassade powder to one part of water stir continuously by hand to obtain a homogeneous lump free paste.
*The mixture should be allowed to stand for 5 minutes prior to applying .

Application:
*Dampen the surface to be tiled with water .
*Spread the adhesive to a required thickness bed and comb with a notched trowel.
*Start placing the tile on surface. Tap the tile properly to ensure complete coverage on the backside of tile and to climate possibility of any air voids.
*Keep joints b/w two tiles using spacer.
*Allow joints to set for 24 hours prior to filling joints.
*Use mechanical damps for holding heavy stone in position on vertical surface.


Usage precautions:
*Always add adhesive to water directly, vice  versa is not recommended.
*Make the paste enough to be used with in 30/60 min pot life.
*Apply adhesive paste that can be tiled with 10  15 min